​
Arcade Services - Indianapolis, Indiana premier arcade rental service provider
317-547-7041​ Email Us
  • Home
  • Events
    • Available Games
    • Event Setup
  • About Us
  • PCB Repair
  • Store
    • Hard Drives
    • Art Work/Marquees
    • Compact Flash Cards
    • Flash Cards Upgrade Kits
    • EPROMS/Security ICs/Components/IDE Cables
    • PC Boards
    • PC Boards / Torx Screws / Wiring
  • Contact Us
  • Tech Tips
    • Tech Tips
    • Events/Rental FAQ
  • Home
  • Events
    • Available Games
    • Event Setup
  • About Us
  • PCB Repair
  • Store
    • Hard Drives
    • Art Work/Marquees
    • Compact Flash Cards
    • Flash Cards Upgrade Kits
    • EPROMS/Security ICs/Components/IDE Cables
    • PC Boards
    • PC Boards / Torx Screws / Wiring
  • Contact Us
  • Tech Tips
    • Tech Tips
    • Events/Rental FAQ
317-547-7041​
Arcade Services - Indianapolis, Indiana premier arcade rental service provider

RUSH 2049 / RUSH 2049 SE

7/1/2019

 
This section will deal with a problem that I see quite often. The boards reset intermittently or all the time. Now, this can be due to a few problems. One is low or high voltage on the plus 5 volts DC. 
As with any Midway / Atari board, it is critical that you adjust the plus 5 volts to 5.10 to 5.15. Do not adjust the voltage while reading the voltage at the power supply because there will be a drop in voltage. You can hook up your digital meter leads on the connector that goes to the hard drive this connector is located on the I/O board with the large Jamma harness that hooks up to it. You will see a 4 pin connector with 2 black and a red and a yellow or orange wires. The red arrow points to the connector. Put your leads between the red and either black wire.
Picture
The second issue that could cause resetting could be the BGA regulator IC that is mounted to a heat sink located on the CPU PCB, which is the middle board. When one or perhaps both custom BGA assembly starts to fail, then it will cause the regulator to get smoking hot, which will cause resetting. EVEN if it is not getting hot and you do no have resetting issues, then I still highly recommend placing a 5 or 12-volt fan directly over the heat sink to keep it cool. (I do have a hard drive fan harness listed on my parts section)This may or may not cure the problem. I have seen this work for a few years. The reason I am showing this to you is that the BGA ICs cannot be replaced, which means that the board is not repairable. You will have to find a used board, which in most cases will cost over $300.00 if you can find one because it is game-specific only to Rush 2049 or Cart Fury, and no other games use these boards.
​Check out the picture below that will show how I have mounted the fan. This does not mean that is how you have to mount it. I have found that this works great, and is simple and fast.

Comments are closed.
Arcade Services
Indianapolis, In
317.547.7041
Email Arcade Services
Rentals/Events
Repair Service
Shop Parts
© 2022 Arcade Services  - All Rights Reserved
Designed by RBA Web Design